The installation instructions for the Argon ONE V3 do state you need to add the following to /boot/firmware/config.txtI own the Argon ONE v3 m.2 nvme case (https://argon40.com/products/argon-one-v3-m-2-nvme-case) and the official Argon power supply (https://argon40.com/products/argon-type ... ts-5-volts) yet I consistently get an undervoltage warning. system performs relatively well otherwise.
disk is a cheaper 2TB one (TEAM TM8PS7002T W0220A0).
any suggestion? is this solvable?
I've read many other posts but could not detect a pattern or solutions.
usb_max_current_enable=1
This is due to the power going through the Argon board, do the Pi cannot negotiate. This is no problem, and my pi5 has worked like this for ages
Statistics: Posted by cct — Sat Sep 13, 2025 6:41 pm