Step 1: connect servo to Pi. Servo power to 5V pin, servo GND to GND pin, servo control pin to your favourite I/O pin.
Step 2: Run pigpio and configure it to output a servo control signal on your favourite I/O pin.
That's it.
In this scenario do not place any load on the servo. If the servo is loaded it may draw too much current and brownout the Pi. You can actually draw a reasonable amount of power for the servo, but focus on getting it working first.
Step 2: Run pigpio and configure it to output a servo control signal on your favourite I/O pin.
That's it.
In this scenario do not place any load on the servo. If the servo is loaded it may draw too much current and brownout the Pi. You can actually draw a reasonable amount of power for the servo, but focus on getting it working first.
Statistics: Posted by ame — Thu Jul 10, 2025 8:03 am