Thanks for advice. I will focus only CAM1 at first.Typ advice:
- start with one camera only.
- make sure to check that boards schematic to see is cam0 on the board is csi0 on the Pi (wouldn't be the first board were the schematics doesn't match the silkscreen printing)
- make sure to check you're using the correct GPIO for the regulator (wired to the CSI interface in use)
1. I will focus on CAM1 (CSI1)
2. Acutal hardware/schematuc is "Confirmed" CAM1 is routed to CSI1
3. Checked. CAM1_IO0 (regualtor pin) for CAM1 is GPIO45. (*CAM0_IO0 = 44)
Statistics: Posted by Amornthep — Fri Jun 20, 2025 4:50 am