In the picture the UPS is already mounted on a piece of acrylic. Maybe four stick-on feet are all that's required for a finished job.I would suggest a "plate" case... SBC and associated gubbins mounts to the bottom plate, which has feet on the bottom side to get it off the surface and make it not slide around. You use standoff posts to connect bottom and top plate together, so can accommodate any height of Pi and gubbins. Pi is protected for having stuff drop onto it and short things out while also having fabulous air flow.
I have a Pi 5 with this setup. It has a Pimoroni NVMe Base, a active cooler and a DAC HAT.
If there are children or grown ups around who are likely to stick their fingers into the fan, one could further get a wire fan guard for that.
Statistics: Posted by ejolson — Fri Aug 02, 2024 4:34 pm